Tonghui TH2829 Series - Transformer Pin Label; Autotrig Delay

TH2829X Series Operation Manual Chapter 7 Transformer Auto Scanning Test
87
7.7.2 TRANSFORMER PIN LABEL
This function is used to set the original transformer pin number as user-defined
number or letter.
TH2829x705
After setting the transformer pin label and the corresponding test conditions, the
instrument will display the data in the mode of user-defined pin label on the
transformer test display page, as shown below:
TH2829x706
7.7.3 AUTOTRIG DELAY
This function is used to trigger test automatically after the DUT has been placed
on the test fixture.
On <TRANSFORMER ID> page, press TOOLS to enter into the <TOOLS> page
The number refers to
transformer pin number.
The number or letter in the
table is self-defined label.
Here is the user-defined pin label.