Tonghui TH2829 Series - Correction Subsystem Commands

TH2829X Series Operation Manual Chapter 10 HANDLER
177
9.1.14 CORRection subsystem commands
The CORRection subsystem commands are mainly used to set the correction
function, OPEN, SHORT, LOAD.
Command tree:
CORRection :LENGth <value>
:METHod SINGle
MULTiple
:OPEN :STATe ON (1)
OFF (0)
:SHORt :STATe ON (1)
OFF (0)
:LOAD :STATe ON (1)
OFF (0)
:TYPE CPD
CPQ
CPG
CPRP
CSD
CSQ
CSRS
LPQ
LPD
LPG
LPRP
LSD
LSQ
LSRS
RX
ZTD
ZTR
ZQ
GB
YTD
YTR
:SPOT<n> :STATe ON (1)
OFF (0)
:FREQuency <value>
:OPEN
:SHORt
:LOAD :STANdard <REF.A>,<REF.B>
:USE :DATA?
:CLEar