Tonghui TH2829 Series - Save Transformer Single-Group Test Result by U Disk

TH2829X Series Operation Manual Chapter 6 Transformer Single-machine Test
79
TH2829x608
On this page, the display results of each parameter will be displayed and the
character color shows the judge result as well. If the judge result is shown red
character which means high pass (H) which yellow character means low pass (L),
green character means PASS.
Users can set the PASS or FAIL beeper on the <SYSTEM> page.
6.5.1 Save transformer single-group test result by U disk
Use U disk to save the test result, the following test results and formats can be
saved:
1：TrTurn :Ns, primary parameter, phase, compare result;
2：TrLx :Lx, primary parameter, secondary parameter, compare result;
3：TrLk :Lk, primary parameter, compare result;
4：TrDcr :Dcr, primary parameter, compare result;
5：TrZx :Zx, primary parameter, secondary parameter, compare result;
6：TrAcr :Acr, primary parameter, secondary parameter, compare result;
7：TrCx :Cx, primary parameter, secondary parameter, compare result.