TH2829X Series Operation Manual Chapter 10 HANDLER
<Judge> format is as below:
<Input/Output> format: The data displays the compare result of the list sweep..
When the compare function of the list sweep measurement is turned off, the
output result of <Input/Output> is 0.
<Input/Output> data output format applies 2-digits ASCII format: SN (S: +/_, N:
from 0 to 1)
On transformer single-machine measurement display page, ASCII data
output format is as below:
SN ， SN.NNNNNESNN ， SN.NNNNNESNN ， SN NL^END
<Serial number><DATA A> <DATA B> <Status>
<SN> is described as below:
Description of <DATA A> is the same as that described above. Secondary
parameter of <DATA B> has two formats:
When the measurement parameter is the turn ratio (TURN), secondary
parameter <DATA B> is the phase and input format is + (in-phase), -
(anti-phase);
When the measurement parameter is inductance (Zx), secondary parameter
<DATA B> is the phase angle θ, its description is the same as that of <DATA A>.
When the measurement parameter is inductance (Acr), secondary parameter of
<DATA B> is inductance X, its description is the same as that of <DATA A>.
When the measurement parameter is inductance Lx, the secondary parameter of
<DATA B> is the quality factor Q, its description is the same as that of <DATA A>.
Meanwhile when the measurement serial number is equal to or larger than 5 (that
is to say testing leakage inductance LK and DC resistance DCR), no secondary
parameter will be displayed but directly display the status. The status format is :
SN: +/_, N is 0/1.
To Next Page
Loading...
