Tonghui TH2829 Series - Page 206

TH2829X Series Operation Manual Chapter 10 HANDLER
197
the output buffer.
For example: WrtCmd (“*TRG”)
 The *CLS command clears the standard event status register and the service
request status register.
Command syntax: *CLS
For example: WrtCmd (“*CLS”)
 The *IDN? query returns TH2829X ID.
Query syntax: *IDN?
Return format:
<manufacturer>,<model>,<firmware>,<hardware>,<date><NL^END>
Where,
<manufacturer> Name of Manufacturer ( Tonghui)
<model> Instrument Model (TH2829AX)
<firmware> Firmware Version (VER1.0.0)
<hardware> Hardware version (Hardware Ver A5.0_L)
<date> Date of the software version (2016-01-11)
For example: WrtCmd(“*IDN?”);
 The *TST? query executes an internal self test and returns the test result as
the sum of all existing errors codes. If there are no error TH2829X returns 0.
Query syntax: *TST?
Return format: 0<NL^END>
Where,
0 0（NR1 format）
For example: WrtCmd(“*TST?”);
 The *ESE (standard Event Status Enable command) command sets each
open bit of the standard event status register. This command returns setups
of each open bit for the standard event status permission register.
Command syntax: *ESE<value>
Where,
<value> NR1 format：decimal expression for each bit of operation status
register.
Descriptions for each byte of the standard event status register are shown as
follows:
Bit number
Description
7
6
5
4
3
2
1
0
Power On(PON) Bit
User Request(URQ) Bit
Command Error(EME) Bit
Execution Error(EXE) Bit
Device Dependent Error(DDE) Bit
Query Error(QYE) Bit
Request Control(RQC) Bit
Operation Complete(OPC) Bit