Tonghui TH2829 Series - Page 22

TH2829X Series Operation Manual Chapter 3 Introduction to [MEAS]
13
 Cs-Q
 Cs-Rs
 ←
Press the soft key corresponding to your desired parameter. Then press ← to
return to upper soft key menu.
4) Press Lp —…→, the following parameters will be shown for your choice.
 Lp-D
 Lp-Q
 Lp-G
 Lp-R p
 ←
Press the soft key corresponding to your desired parameter. Then press ← to
return to upper soft key menu.
5) Press Ls —…→, the following parameters will be shown for your choice.
 Ls-D
 Ls-Q
 Ls-R s
 ←
Press the soft key corresponding to your desired parameter. Then press ← to
return to upper soft key menu.
6) Press Z—…→, the following parameters will be shown for your choice.
 Z-d
 Z-r
 Z-Q
 ←
Press the soft key corresponding to your desired parameter. Then press ← to
return to upper soft key menu.
7) Press ↓, another group of soft keys will be shown.
 Y—…→
 R—…→
 G—B
 DCR
 ←
Press the soft key corresponding to your desired parameter. Then press ← to
return to upper soft key menu.
8) Press Y—…→, the following parameters will be shown for your choice.
 Y-d
 Y-r
 ←
Press the soft key corresponding to your desired parameter. Then press ← to
return to upper soft key menu.
9) Press R—…→, the following parameters will be shown for your choice.
 R-X
 Rp-Q