TH2829X Series Operation Manual Chapter 4 [SYSTEM] and [FILE]
coordination range of primary and secondary parameter, which is used to
formulate the frequency response curve drawing range.
Move cursor to zone, input operation: Select the number you need on
keyboard (0
～9/+, -/. ) and press enter key or select a corresponding unit.
The instrument default is automatic coordinate. When the user lock the
coordinate, manual setting is needed. As the same, the MAX should be greater
than the MIN, or error message will be displayed on the screen.
A DIV and B DIV indicate the range of each cell in vertical coordinate.
Adjusting the value can change the maximum and minimum value of vertical
coordinate. At the same time, the distribution situation of the trace in coordinate
system will also be changed. This parameter can help observe and analyze the
trend of the sweep trace.
To Next Page
Loading...
