219
APPENDIX 1
[Analysis] tab
• Reanalysis
• Disc Topo
Item Contents of setting
Auto reposition
(3D Disc Circle/ETDRS
Grid/Fovea position)
For 3D Disc Circle/ETDRS Grid/Fovea position, specify whether the manual
position modification or the automatic position detection should be adopted
when reanalysis is performed.
Don't show the reanaly-
sis message.
Specify whether the message "Old analysis data exists. Do you reanalyze?"
should be displayed or not. When you set "On", reanalysis is not done even
if the old analysis data is opened.
Item Contents of setting
Reference plane height
You can change the reference plane height to decide the cup margin in optic
disc analysis. Default is 120µm. It is possible to change the default to
"60µm", "90µm" and "Custom".
To Next Page
Loading...
Need help?
General
