2. Type telnet 192.168.0.1 in the command prompt shown as Figure 1-9, and press the Enter
button.
Figure 1-10 Connecting to the Switch
3. You are prompted to enter the connection password 456 you have set through Console
port connection, and then you are in User EXEC Mode.
Figure 1-11 Enter into the User EXEC Mode
4. Type enable command to enter Privileged EXEC Mode.
Figure 1-12 Enter into the Privileged EXEC Mode
Now you can view your switch settings with CLI commands through Telnet connection.
Note:
1. Users login via Login Mode are defined as user-level and they have no permission to
configure the switch.
2. You can refer to Chapter 11 User Management Commands for detailed commands
information of the Telnet connection configuration.
9
To Next Page
Loading...
