Uson Qualitek mR - Chapter 1: Safety; 1.1 Introduction; 1.2 Materials Disposal

Safety 1-1
1
Chapter 1 Safety
1.1 Introduction
This section explains the warnings and cautions that should be observed when
installing or operating the Qualitek mR.
Safety information is covered at relevant points throughout the manual. Please
read this manual in its entirety before installing or operating the instrument.
Should any point remain unclear, contact your supplier for assistance before
proceeding.
The tester is designed for installation and use in an industrial environment by
suitably trained personnel.
1.2 Materials Disposal
Uson is committed to meeting the requirements of the European Union (EU)
Waste Electrical and Electronic Equipment (WEEE) Directive. Uson products that
are within the scope of the Directive are labelled with
a crossed-out "wheelie-bin" symbol, as required by the
Directive. It indicates that the product was placed on
the market after August 13, 2005 and that end users
should segregate the product from other waste at end-
of- life.
The detailed requirements vary considerably
throughout the EU, and the Uson WEEE compliance
approach varies among countries.