Run Mode 5-11
5.2.3.1 Calibrate Button Availability
The Calibrate button is available only when the Measure Type of the current
program is set to Leak Rate and Pressure Decay as shown. (The test type is set in
Program Mode. See "Specifications" on page 6-4.) Otherwise, the button is
dimmed and not available for use.
The Calibrate
button is dimmed if
the test type of the
current program is
not a Leak Rate and
Pressure Decay
type test.
In Program Mode,
the Measure Type
must be Leak Rate
and Test Type
Pressure Decay for
the Calibrate
Button to become
available.
To Next Page
Loading...
