Uson Qualitek mR - System Status; Test Status

9-4 Qualitek mR Owner’s Guide
9.2.3 System Status
9.2.4 Test Status
Digital
Input
Address
(decimal)
Name/description of 8-bit values
10001 1 Ready-to-run (1 = ready, 0 = not ready)
10002 2 Start-of-cycle (1 = SOC, 0 = not at SOC)
10003 3 End-of-cycle (1 = EOC, 0 = not at EOC)
10004 4 Busy (1 = busy, 0 not busy)
10005 5 Alarm (1 = Alarm, 0 = no alarm)
10006 6 Pressure OK (1 = ok, 0 = not ok)
10007 7 Isolate (1 = active, 0 = not active)
Digital
Input
Address
(decimal)
Name/description of 8-bit values
10008 8 Test Pass (1 = Pass, 0 = no result)
10009 9 Test Fail (1 = Fail, 0 = no result)