8-36 Qualitek mR Owner’s Guide
Attach the scanner to the tester’s USB port (front or rear) and cycle the tester
power so that it can recognize that the scanner is attached. Us the scanner to scan
the codes below to configure the scanner.
Scan the following bar codes, in order:
• Restore Default
• Interface Selection
• Data Format Terminator
• Language.
(The Language must correspond to the language that is selected in the Program
Mode > System Options > General Tab > Language.)
Please refer to the Quick Reference Guide that is packed with the scanner for
additional information about operating the scanner.
RESTORE DEFAULT
RESTORE DEFAULT
Ì$+$*oÎ
INTERFACE SELECTION
USB-COM
Ì$+UA02$-4Î
DATA FORMAT TERMINATOR
CR-LF
Ì$+EA120D0A$-ÃÎ
To Next Page
Loading...
