Engine (continued)
16. Prime the fuel system.
17. Start the engine and inspect the machine for any leaks.
18. Allow the machine to reach operating temperature level, check and adjust the
coolant level as necessary.
Removing and Installing the Drive Shaft
Figure 14
1. Stub Shaft
2. Washer
3. Mounting bolt
4. U-joint
5. Pinch bolt
6. Washer
7. Nut
1. Remove attachments from the machine.
2. Park the machine on a level surface, engage the parking brake, and remove the
key from the ignition.
3. Switch the main circuit breaker to the O
FF position, to de-energize the electrical
system.
4. Remove the radiator; refer to 4520P Removing the Radiator, page 4–15.
5. Remove the canvas cover.
4520P Page 4–19 Engine: Engine Service and Repairs
09.40003Rev 00
To Next Page
Loading...
