February, 2008
6-64
WorkCentre 5225, 5230
Launch Version
General Procedures
Chain 770-xxx 840-xxx Scan Service
770-159 IPv6 Gateway Address for Auto Configura-
tion
Null Indicates IPv6 address in (null-terminated) literal format (prefix is 64 bits)
770-160 MFIO Port Enable 0: Disable 0~1 0: Disable, 1: Enable
770-163 SNMP Protocol version 1 1~255 1: V1/V2C, 2: V3 (The bit corresponding to the valid bit is turned on)
770-166 HTTP Max Session 5 1~15 1~15
770-179 SLP Version 1 1~2 1: PFRSC_SYS_SLP_V1, 2: PFRSC_SYS_SLP_V2
770-190 Mail Service Start/Stop 1: Start 0~1 1: Start, 0: Stop
770-191 Address of Mail Sender NULL ASCII Max number of characters 128 (Character type: alphabet, [@] [.] [+] [-] [=] [_] (under-
score) [/] [<] [>]) in the format username@domain.name
770-222 port9100 Starting setup 1 0~1 0: Disable 1: Enable
770-250 USB Adobe Protocol 0 0~3 0: Standard 1: Binary 2: TBCP, 3: RAW Mode
770-251 USB JCL(FX)/PJL(AP) Enable 1 0~1 0: Off 1: On
770-252 USB Print Mode Type 1 1~29 1: Auto, 14: Dump, 15: ART, 16: PLW, 3: HPGL2, 8: ESCP, 5: PostScript, 10: TIFF, 2: PCL,
17: KS5843, 18: KSSM, 29: KS5895 Refer to the FF Host I/F of each product for the setting
range.
770-254 USB Port Enable 1 0~1 0: Disable 1: Enable
770-255 USB Auto Feed Time 6 (30sec) 1~255 1~255 (5~1275 sec.) (unit: 5 sec.)
770-280 Mail Print Starting Setup 1: Enable 0~1 0: Disable, 1: Enable
770-281 Mail Print File Type 1 1~29 1: Auto, 14: Dump, 15: ART, 16: PLW, 3: HPGL2, 8: ESCP, 5: PostScript, 10: TIFF, 2: PCL,
17: KS5843, 18: KSSM, 29: KS5895
770-282 Mail Print JCL Switch 1 0~1 0: Off, 1: On
770-283 Mail Print Filter 0 0~1 0: None, 1: TBCP
770-284 Mail Print Spool Type 0: Non Spool 0~1 0: Non Spool (Ring Buffer), 1: Spool (RAM Disk)
770-285 Mail Print with Header Print 1: Print basic headers and
contents
0~4 0: Print all headers and contents, 1: Print basic headers and contents, 2: Do not print head-
ers or contents, 3: Auto print according to content, 4: Print entire header and body (S/MIME
data included)
770-286 POP Server User Name NULL -
770-287 POP Server Password NULL -
770-290 UPnP Enable 1: Enable 0~1 0: Disable 1: Enable
770-291 UPnP Port Number 80 1~65535 1 to 65535
770-295 BMLinkS Print Service Enable 1: Enable 0~1 0: Disable 1: Enable
770-296 BMLinkS Discovery Service Port No. 80 1~65535 1 to 65535
770-297 BMLinkS Print Service Port No. 80 1~65535 1 to 65535
770-320 Sesami Port Enable 1: Enable 0~1 0: Disable, 1: Enable
Table 5 I/O Port Protocol
Chain-
Link Content Default Range Meaning
Table 6 Scan Service
Chain-
Link
Content Default Range Meaning
770-301 LDAP Server Name Primary NULL 64bytes or below. Refer to RFC1034 for the available characters.
To Next Page
Loading...
Need help?
General
