7-9
THROTTLE BODY
EAS30475
CHECKING THE INJECTORS (BEFORE
REMOVING)
1. Check:
• Injector
Use the diagnostic code numbers “36”–“37”.
Refer to “DIAGNOSTIC CODE: ACTUATOR
OPERATION TABLE” on page 9-62.
EAS31158
REMOVING THE FUEL HOSE (FUEL RAIL
SIDE)
1. Remove:
• Fuel tank
Refer to “REMOVING THE FUEL TANK” on
page 7-3.
2. Remove:
• Fuel hose (fuel rail side)
ECA17490
Be sure to disconnect the fuel hose by hand.
Do not forcefully disconnect the hose with
tools.
• To remove the fuel hose from the fuel rail joint,
slide the fuel hose connector cover “1” on the
end of the hose in the direction of the arrow
shown, press the two buttons “2” on the sides
of the connector, and then remove the hose.
• Before removing the hose, place a few rags in
the area under where it will be removed.
• It is prohibited to wear the cotton work gloves
or equivalent coverings.
EAS30476
REMOVING THE INJECTORS
WARNING
EWA20210
• Check the injectors in a well-ventilated area
free of combustible materials. Make sure
that there is no smoking or use of electric
tools in the vicinity of the injectors.
• Be careful when disconnecting the fuel
hose. Any remaining pressure in the fuel
hose may cause the fuel to spray out. Place
a container or rag under the hose to catch
any fuel that spills. Always clean up any
spilt fuel immediately.
• Push the OFF/LOCK switch and disconnect
the negative battery lead from the battery
terminal before removing the injectors.
1. Remove:
• Fuel rail “1”
a. Remove the fuel rail screws “2” as shown.
EAS30477
CHECKING THE INJECTORS
1. Check:
• Injector
Obstruction Replace and check the fuel
pump/fuel supply system.
Deposit Replace.
Damage Replace.
2. Check:
• Injector resistance
Refer to “CHECKING THE FUEL INJEC-
TOR” on page 8-111.
To Next Page
Loading...
