EasyManua.ls Logo

Yamaha TMAX TECH MAX 2020 - PERIODIC MAINTENANCE CHART FOR THE EMISSION CONTROL SYSTEM; GENERAL MAINTENANCE AND LUBRICATION CHART

Yamaha TMAX TECH MAX 2020
688 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-1
PERIODIC MAINTENANCE
EAS20022
PERIODIC MAINTENANCE
EAS30022
INTRODUCTION
This chapter includes all information necessary to perform recommended checks and adjustments. If
followed, these preventive maintenance procedures will ensure more reliable vehicle operation, a lon-
ger service life and reduce the need for costly overhaul work. This information applies to vehicles al-
ready in service as well as to new vehicles that are being prepared for sale. All service technicians
should be familiar with this entire chapter.
TIP
Items marked with an asterisk should be performed by your Yamaha dealer because these items
require special tools, data, and technical skills.
From 50000 km (30000 mi), repeat the maintenance intervals starting from 10000 km (6000 mi).
The annual checks must be performed every year, except if a distance-based maintenance is
performed instead.
EAS30614
PERIODIC MAINTENANCE CHART FOR THE EMISSION CONTROL SYSTEM
EAS30615
GENERAL MAINTENANCE AND LUBRICATION CHART
No. ITEM
CHECK OR MAINTENANCE
JOB
ODOMETER READINGS
ANNUAL
CHECK1000 km
(600 mi)
10000 km
(6000 mi)
20000 km
(12000 mi)
30000 km
(18000 mi)
40000 km
(24000 mi)
1 * Fuel line
Check fuel hoses for cracks or
damage.
Replace if necessary.

2 * Spark plugs
Check condition.
Adjust gap and clean.

Replace. 
3 * Valve clearance Check and adjust. Every 40000 km (24000 mi)
4 * Fuel injection
Check engine idle speed. 
Check and adjust synchroni-
zation.

5 * Exhaust system
Check for leakage.
Tighten if necessary.
Replace gaskets if necessary.

6*
Evaporative emis-
sion control sys-
tem
Check control system for
damage.
Replace if necessary.

No. ITEM
CHECK OR MAINTENANCE
JOB
ODOMETER READINGS
ANNUAL
CHECK1000 km
(600 mi)
10000 km
(6000 mi)
20000 km
(12000 mi)
30000 km
(18000 mi)
40000 km
(24000 mi)
1*
Diagnostic sys-
tem check
Perform dynamic inspection
using YDT.
Check the DTCs.

2 * Air filter element Replace. 
3*
Air filter case
check hose
Clean. 
4*
V-belt case air fil-
ter elements
Clean. 
Replace. 
5 * Front brake
Check operation, fluid level,
and for fluid leakage.
Replace brake pads if neces-
sary.


Table of Contents

Related product manuals