2-16
CABLE ROUTING
1. Headlight control unit
2. Clamp
3. Front turn signal light coupler
4. Headlight sub-wire harness
5. Headlight assembly lead
A. Do not pass the wire harness through this
location.
B. After assembling the headlight, route wires
to the wire harness.
C. Fasten the headlight sub-wire harness and
headlight assembly lead with the clamp
between the right cover and the headlight
assembly mounting boss (within the range
shown in the illustration). The direction of
the clamp does not matter.
D. Route the headlight sub-wire harness
(going to the right turn signal light) in front
of the headlight assembly lead.
E. Fully push in the blue tape section of the
headlight sub-wire harness all the way to
the back of the rib section of the headlight
assembly.
F. Install the green tape section of the head-
light sub-wire harness to the rib section of
the headlight assembly.
G. Install the white tape section of the head-
light sub-wire harness to the rib section of
the headlight assembly.
H. Route the headlight sub-wire harness
(going to the left turn signal light) in rear of
the headlight assembly lead.
I. Push in the lead all the way to the back of
the rib.
To Next Page
Loading...
