2-20
CABLE ROUTING
1. Storage box light switch lead
2. Rear wheel sensor lead
3. Battery charger terminal (OPTION)
4. O
2
sensor lead
5. Storage box light lead
6. Storage box
7. Storage box rib
8. Starter motor lead
9. Rear brake lock cable
10. Brake hose
11. Wire harness
A. Route the fuel pump lead under the rear
frame.
B. To rear wheel sensor
C. Install the clamp of the O
2
sensor lead into
the hole of the V-belt case air filter case.
D. To seat lock cylinder
E. To seat heater (for XP560D)
F. Fasten the storage box light switch lead
with the clamp.
G. It does not matter whether the storage box
light leads are installed on the left or right
of the storage box light.
H. Install the clamp of the seat heater lead
against the rib of the storage box.
I. Around the starter motor
J. Push in the starter motor lead underneath
the V-belt case air duct.
K. Install the clamp within the range shown in
the illustration.
L. Install the O
2
sensor coupler to the rear
brake lock cable bracket.
M. Fully insert the clamp all the way to the
back of the rear frame rib.
N. Install the O
2
sensor lead to the rib.
To Next Page
Loading...
