9-72
P0030
For this check, also set the engine stop switch to “ON”.
4. Defective O
2
sensor heater.
• Replace the O
2
sensor.
Refer to “ENGINE REMOVAL” on page 5-7.
• Push the ON/start switch, and then check the condition of the DTC using the malfunction mode of the
YDT.
For this check, also set the engine stop switch to “ON”.
5. Malfunction in ECU.
• Replace the ECU, and complete the service.
Refer to “REPLACING THE ECU (Engine Control Unit)” on page 8-93.
6. Delete the DTC and check that the MIL goes off.
• Confirm that the DTC has a condition of “Recovered” using the YDT, and then delete the DTC.
Is it in the “Recovered” condition?
YES
Go to step 6, and complete the service.
NO
Start the engine, and then check the condition of the DTC.
Is it in the “Recovered” condition?
YES
Go to step 6, and complete the service.
NO
Go to step 4.
Is it in the “Recovered” condition?
YES
Go to step 6, and complete the service.
NO
Start the engine, and then check the condition of the DTC.
Is it in the “Recovered” condition?
YES
Go to step 6, and complete the service.
NO
Go to step 5.
To Next Page
Loading...
Need help?
General
