EasyManuals Logo

Yamaha TMAX TECH MAX 2020 User Manual

Yamaha TMAX TECH MAX 2020
688 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #547 background imageLoading...
Page #547 background image
9-73
P00D1, P2195
EAS20660
P00D1, P2195
EAS33115
TROUBLESHOOTING
Item
[P00D1] O
2
sensor: heater performance deterioration
[P2195] O
2
sensor: open circuit detected.
Fail-safe system
Able to start engine
Able to drive vehicle
Procedure
TIP
If more than one DTC is detected at the same time, perform troubleshooting of DTC listed below first.
1. P0657
2. P0030
1. Installed condition of O
2
sensor.
Check for looseness or pinching.
2. Connection of O
2
sensor coupler.
Check the locking condition of the coupler.
Disconnect the coupler and check the pins (bent or broken terminals and locking condition of the
pins).
Is check result OK?
YES
Go to step 2.
NO
a. Reinstall or replace the O
2
sensor.
Refer to “ENGINE REMOVAL” on page 5-7.
b. Start the engine and let it idle for approximately 1 minute.
c. Check the condition of the DTC using the malfunction mode of the YDT.
Is it in the “Recovered” condition?
YES
Go to step 8, and complete the service.
NO
Go to step 2.
Is the coupler condition normal?
YES
Go to step 3.
NO
a. Connect the coupler securely or replace the wire harness.
b. Start the engine and let it idle for approximately 1 minute.
c. Check the condition of the DTC using the malfunction mode of the YDT.
Is it in the “Recovered” condition?
YES
Go to step 8, and complete the service.
NO
Go to step 3.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha TMAX TECH MAX 2020 and is the answer not in the manual?

Yamaha TMAX TECH MAX 2020 Specifications

General IconGeneral
BrandYamaha
ModelTMAX TECH MAX 2020
CategoryMotorcycle
LanguageEnglish

Related product manuals