9-76
P00D1, P2195
5. Check fuel pressure.
• Check the fuel pressure.
Refer to “CHECKING THE FUEL PRESSURE” on page 7-12.
6. Defective O
2
sensor.
• Check the O
2
sensor.
7. Malfunction in ECU.
• Replace the ECU, and complete the service.
Refer to “REPLACING THE ECU (Engine Control Unit)” on page 8-93.
8. Delete the DTC and check that the MIL goes off.
• Confirm that the DTC has a condition of “Recovered” using the YDT, and then delete the DTC.
Is it in the “Recovered” condition?
YES
Go to step 8, and complete the service.
NO
Go to step 5.
Is check result OK?
YES
Go to step 6.
NO
a. Replace the fuel pump.
Refer to “REMOVING THE FUEL PUMP” on page 7-3.
b. Start the engine and let it idle for approximately 1 minute.
c. Check the condition of the DTC using the malfunction mode of the YDT.
Is it in the “Recovered” condition?
YES
Go to step 8, and complete the service.
NO
Go to step 6.
Is check result OK?
YES
Go to step 7.
NO
a. Replace the O
2
sensor.
Refer to “ENGINE REMOVAL” on page 5-7.
b. Start the engine and let it idle for approximately 1 minute.
c. Check the condition of the DTC using the malfunction mode of the YDT.
Is it in the “Recovered” condition?
YES
Go to step 8, and complete the service.
NO
Go to step 7.
To Next Page
Loading...
Need help?
General
