9-138
P062F
EAS20598
P062F
EAS33078
TROUBLESHOOTING
Item
EEPROM DTC: an error is detected while reading or writing on EEPROM.
Fail-safe system
• Able/Unable to start engine
• Able/Unable to drive vehicle
Procedure
1. Locate the malfunction.
• Execute the diagnostic mode (Code D60)
00
Go to step 5.
01
Go to step 2.
02
Go to step 3.
Except 00–04
Go to step 4.
2. “01” is indicated in diagnostic mode (code D60). EEPROM data error for adjustment of CO concen-
tration of cylinder #1.
• Change the CO concentration of cylinder #1, and rewrite in EEPROM.
Refer to “ADJUSTING THE EXHAUST GAS VOLUME” on page 3-12.
• After this adjustment is made, push the OFF/LOCK switch.
• Push the ON/start switch, and then check the condition of the DTC using the malfunction mode of the
YDT.
3. “02” is indicated in diagnostic mode (code D60). EEPROM data error for adjustment of CO concen-
tration of cylinder #2.
• Change the CO concentration of cylinder #2, and rewrite in EEPROM.
Refer to “ADJUSTING THE EXHAUST GAS VOLUME” on page 3-12.
• After this adjustment is made, push the OFF/LOCK switch.
• Push the ON/start switch, and then check the condition of the DTC using the malfunction mode of the
YDT.
Is it in the “Recovered” condition?
YES
Go to step 6, and complete the service.
NO
a. Repeat step 1.
b. If the same number is indicated, go to item 5.
Is it in the “Recovered” condition?
YES
Go to step 6, and complete the service.
NO
a. Repeat step 1.
b. If the same number is indicated, go to item 5.
To Next Page
Loading...
Need help?
General
