9-139
P062F
4. Except “00-04” is indicated in diagnostic mode (Code D60). EEPROM data error for corresponding
learning/memory values.
• Push the OFF/LOCK switch.
• Push the ON/start switch, and then check the condition of the DTC using the malfunction mode of the
YDT.
5. Malfunction in ECU.
• Replace the ECU, and complete the service.
Refer to “REPLACING THE ECU (Engine Control Unit)” on page 8-93.
6. Delete the DTC and check that the MIL goes off.
• Confirm that the DTC has a condition of “Recovered” using the YDT, and then delete the DTC.
Is it in the “Recovered” condition?
YES
Go to step 6, and complete the service.
NO
a. Repeat step 1.
b. If the same number is indicated, go to item 5.
To Next Page
Loading...
