9-161
P2122, P2123, P2127, P2128, P2138
5. Malfunction in ECU.
• Replace the ECU, and complete the service.
Refer to “REPLACING THE ECU (Engine Control Unit)” on page 8-93.
6. Delete the DTC and check that the MIL goes off.
• Confirm that the DTC has a condition of “Recovered” using the YDT, and then delete the DTC.
Is check result OK?
YES
Go to step 5.
NO
Replace the
accelerator position sensor.
Refer to “HANDLEBAR” on page 4-74.
Is it in the “Recovered” condition?
YES
Go to step 6, and complete the service.
NO
Go to step 5.
To Next Page
Loading...
Need help?
General
