2-60
CABLE ROUTING
1. Rear brake hose (hydraulic unit to rear
brake caliper)
2. Rear brake hose (rear brake master cylin-
der to hydraulic unit)
3. Front brake hose (front brake master cylin-
der to hydraulic unit)
4. Front brake hose (hydraulic unit to front
brake caliper)
5. Hydraulic unit
A. Brake hose installation order
1.Install the rear brake hose“1” at the indi-
cated angle. Install the front brake hose “3”
with the L-shaped pin in contact with the
side of the hydraulic unit. (The installation
order of rear brake hose “1” and front
brake hose “3” does not matter.)
2. Install the front brake hose “4” with the
protrusion in contact with the metal part of
front brake hose “3”. Install the rear brake
hose “2” with the protrusion in contact with
the metal part of rear brake hose “1”. (The
installation order of front brake hose “4”
and rear brake hose “2” does not matter.)
3. Tighten the mounting bolts of each
brake hose to the specified torque. (In no
particular order)
B. 14.6–18.6
C. 16–20
To Next Page
Loading...
Need help?
General
