3.7 Top Protective Cover
The drive is designed to NEMA Type 1 specifications with a protective cover on the top. Removing this top protective cover
or the bottom conduit bracket from an IP20/NEMA Type 1 drive voids the NEMA Type 1 protection while maintaining IP20
conformity.
u
Removing the Top Protective Cover
Insert the tip of a straight-edge screwdriver into the small opening located on the front edge of the top protective cover. Gently
apply pressure as shown in the figure below to free the cover from the drive.
Note: Removing the top protective cover or the bottom conduit bracket from an IP20/NEMA Type 1 drive voids the NEMA Type 1 protection while
maintaining IP20 conformity.
Figure 3.10 Removing the Top Protective Cover
u
Reattaching the Top Protective Cover
Insert the two small protruding hooks on the rear side of the top protective cover into the provided mounting holes near the
back of the drive, then press down on the front side of the top protective cover to fasten the cover into place.
Protective Cover
Mounting Holes
Figure 3.11 Reattaching the Protective Cover
3.7 Top Protective Cover
YASKAWA ELECTRIC SIEP C710616 31B YASKAWA AC Drive – A1000 Technical Manual
57
3
Electrical Installation
To Next Page
Loading...
Need help?
General
