4.4 Start-Up Flowcharts
The flowcharts in this section summarize basic steps required to start the drive. Use the flowcharts to determine the most
appropriate start-up method for a given application. The charts are intended as a quick reference to help familiarize the user
with start-up procedures.
Flowchart Subchart Objective Page
A – Basic start-up procedure and motor tuning 92
–
A-1 Simple motor setup using V/f mode 93
A-2
High-performance operation using Open Loop Vector (OLV) or Closed Loop Vector (CLV) motor
control
94
A-3
Setting up the drive to run a permanent magnet (PM) motor
Note: PM motor control modes are not available on 600 V class drives,
CIMR-Ao5oooooooo.
95
Note: Refer to Application Selection on page 97 to set up the drive using one of the Application Presets.
4.4 Start-Up Flowcharts
YASKAWA ELECTRIC SIEP C710616 31B YASKAWA AC Drive – A1000 Technical Manual
91
4
Start-Up Programming
& Operation
To Next Page
Loading...
