YASKAWA DX200 - Page 145

8-58
182582-1CD
182582-1CD
8 System Setup
8.6 Interference Area
MH900, DX200 Controller
2. Move the manipulator at the maximum and minimum value positions of
the cube corner using the axis keys.
3. After entering the lengths of the three faces of the cube (axial length)
using the Numeric keys, move the manipulator to the center point of
the cube using the axis keys.
Minimum
value
X-axis
Y-axis
Z-axis
Maximum
value
Cubic
interference
area axis
Minimum
value
X-axis
Y-axis
Z-axis
Maximum
value
X-axis
Y-axis
Z-axis
Center
point
X
Y
Z
145 of 552