8 System Setup
8.23Safety Logic Circuit
8-205
182582-1CD
182582-1CD
MH900, DX200 Controller
– Press “YES”, and then the file is updated.
The file transferred to the machine safety circuit board
(type:YSF21-E) is written in the FLASH ROM.
The status becomes “DONE” from “NOT DONE”.
If press “NO”, the file will not be updated. The status remains “NOT
DONE”.
• If press “YES” on the confirmation dialog, the all window
information, such as {M-SAFETY SIGNAL ALLOC},
{SAFETY SIG. BOARD ALLOC}, {TIMER DELAY SET},
and {SAFETY LOGIC CIRCUIT} are updated. The
written file in the FLASH ROM of the machine safety
circuit board is also updated.
• When performing {WRITE}, the universal safety and the
safety field bus output signals, which are sent from the
machine safety circuit board, are turned OFF till the
writing processing is finished.
To Next Page
Loading...
