YASKAWA DX200 - Page 331

8-244
182582-1CD
182582-1CD
8 System Setup
8.23Safety Logic Circuit
MH900, DX200 Controller
8.23.4.10 Setting for the Universal Safety Output Signals
The general safety output signals (type: YSF24-E) that have been used
only on the optional functional safety board can be also used in the safety
logic circuit.
1. Select {SAFETY FUNC.}-{F-SAFETY SIGNAL ALLOC} to display the
following window. The marks at the right end indicates OFF/ON status.
The mark “ ᇲ ” means OFF and the mark “●” means ON.
2. To use the universal safety output signals in the safety logic circuit,
press the select key on the programming pendant and set “YSF21-E”.
The universal safety output signals allocated to “YSF21-E” are
available in the safety logic circuit. However, if the setting is “NOT
USED”, the signals are available only on the functional safety board as
usual.
331 of 552