8 System Setup
8.23Safety Logic Circuit
8-245
182582-1CD
182582-1CD
MH900, DX200 Controller
3. Select “WRITE” and then “CONFIRM” to enable the changed settings.
When the data is updated correctly, the status on the title line is
changed from NOT DONE to DONE.
8.23.4.11 Setting for the Safety Signal Allocation Board
This window is displayed only when the optional safety field bus function
is enabled.
1. Select {SAFETY FUNC.}-{SAFETY SIG. BOADR ALLOCATION}. The
marks at the right end indicates OFF/ON status. The mark “ ᇲ ”
means OFF and the mark “●” means ON. Also, comments (up to 32
characters) can be input.
To Next Page
Loading...
