9-17
182582-1CD
182582-1CD
9 System Backup
9.3 Automatic Backup Function
MH900, DX200 Controller
D. RETRY CYCLE
Specify the length of time for a cycle to retry backing up when the
backup operation is suspended.
After being suspended, the backup is retried in the time specified in the
RETRY CYCLE.
Set the retry cycle in units of minutes. The cycle setting ranges from 0 to
255, and is shorter than the BACKUP CYCLE.
When it is set to 0, retry will not be performed.
E. MODE CHANGE BACKUP
Set the automatic backup function to be valid or invalid when the mode
is switched from teach mode to play mode.
Each time [SELECT] is pressed, “INVALID” and “VALID” are displayed
alternately.
F. STARTUP AUTO BACKUP
Set the backup function to be valid or invalid when the power of the
controller is turned ON.
Each time [SELECT] is pressed, “INVALID” and “VALID” are displayed
alternately.
G. SPECIFIC INPUT BACKUP
Set the backup function to be valid or invalid when specific input signal
(# 40560) is input (rising edge from 0 to 1).
Each time [SELECT] is pressed, “INVALID” and “VALID” are displayed
alternately.
H. UNIV.OUT NO. ON ERROR
Set “1” to the specified user output signal which was specified in this
chapter when the automatic backup error occurs.
The term “automatic backup error” here means that the backup is not
performed successfully before the next backup (including retry opera-
tion) starts.
I. DISPLAY AT EMERGENCY
Set the method of notification of the automatic backup error to
“ERROR” or “MESSAGE.”
Each time [SELECT] is pressed, “ERROR” and “MESSAGE” are dis-
played alternately.
J . DURING ALARM OCCURRENCE
Set the backup function to be valid or invalid when an alarm occurs.
Each time [SELECT] is pressed, “INVALID” and “VALID” are displayed
alternately.
To Next Page
Loading...
