YASKAWA DX200 - Page 434

12 Modification of System Configuration
12.2Allocating External I/O Signal
12-6
182582-1CD
182582-1CD
MH900, DX200 Controller
3. Select the allocation mode to set.
– To operate the I/O signal allocation automatically, select the
allocation mode “AUTO”.
– To operate the I/O signal allocation manually, select the allocation
mode “MANUAL”.
– Selected allocation mode appears.
4. Select “DETAIL” under the “EXTERNAL IO ALLOCATION”.
– The External Input Signals Allocation window appears.
– When select the “AUTO”, skip the following procedures from No. 5
to No. 7. Operate from the procedure No. 8.
– S for the allocation mode “MANUAL”, operate the following
procedures.
434 of 552