12-13
182582-1CD
182582-1CD
12 Modification of System Configuration
12.2Allocating External I/O Signal
MH900, DX200 Controller
< Setting example: Automatic setting >
When the automatic setting is performed by external IO allocation, IO data
is allocated to the external IO signals from lower to higher numbers.
In this case, the following contents are shown in the external IO setting
window.
<6)<,2131
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
-%716/$9(
࡞ࡋ
࡞ࡋ
࡞ࡋ
እ㒊ධຊಙྕ㡿ᇦ
㹼
㹼
㹼
㹼
㹼
㹼
㹼
㹼
㹼
㹼
࣭࣭࣭
እ㒊ฟຊಙྕ㡿ᇦ
㹼
㹼
㹼
㹼
㹼
㹼
㹼
㹼
㹼
㹼
࣭࣭࣭
I/O module setting
BOARD
DI DO AI AO
IO MODULE
ST#
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
External input signal area
External output signal area
<6)
-%71
-%71
<6)
-%71
-%71
External IO allocation setting
EXTERNAL IO ALLOCATION (INPUT)
EXTERNAL IO ALLOCATION (OUTPUT)
ST# CH MAC ID ADDR BYTE NAME
ST# CH MAC ID ADDR BYTE NAME
GP input data (40 points)
Board status (8 points)
Input data (16 points)
GP output data (40 points)
System area (8 points)
Output data (16 points)
To Next Page
Loading...
