12 Modification of System Configuration
12.2Allocating External I/O Signal
12-14
182582-1CD
182582-1CD
MH900, DX200 Controller
< Setting example: Allocating the CC-Link board data only by manual
setting >
IO data of the CC-Link can be allocated from the top while data of the
board status/system area allocated to different area.
In this case, the following contents are shown in the external IO setting
window.
<6)<,2131
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
࡞ࡋ
-%716/$9(
࡞ࡋ
࡞ࡋ
࡞ࡋ
እ㒊ධຊಙྕ㡿ᇦ
㹼
㹼
㹼
㹼
㹼
㹼
㹼
㹼
㹼
㹼
࣭࣭࣭
እ㒊ฟຊಙྕ㡿ᇦ
㹼
㹼
㹼
㹼
㹼
㹼
㹼
㹼
㹼
㹼
࣭࣭࣭
I/O module setting
IO MODULE
BOARD
DI DO AI AO
ST#
Not allocated
Not allocated
Input data is allocated from the top
Output data is allocated from the top
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
NONE
Data of the system area is
allocatedto different area
Data of the board status is allocated
to different area
External input signal area
External output signal area
-%71
-%71
-%71
-%71
External IO allocation setting
EXTERNAL IO ALLOCATION (INPUT)
ST# CH MAC ID ADDR BYTE NAME
EXTERNAL IO ALLOCATION (OUTPUT)
ST# CH MAC ID ADDR BYTE NAME
Board status (8 points)
Input data (16 points)
System area (8 points)
Output data (16 points)
To Next Page
Loading...
