14-18
182582-1CD
182582-1CD
14 Description of Units and Circuit Boards
14.6Machine Safety Terminal Block Circuit Board (JANCD-YFC22-E)
MH900, DX200 Controller
below and push straight down.
(2) Insert the wire into the connection hole slowly until its leading end
touches the end of the hole.
For thin wires, never insert the wire with force, or the wire
jacket may get caught in.
(3) Pull out the screwdriver to clamp the conductor with a spring.
(4) Check if the wire is connected firmly by pulling the wire softly.
To Next Page
Loading...
