Description and Basic Operation of the SDA-5500 and 5510: Global Configuration
227
13
the OK soft key. The screen displays the noise floor, expressed in the
currently selected units (e.g. dBmV).
Channel Plan Setup
Selecting the CHANNEL PLAN option from the CONFIGURE menu takes
you to a screen where you can set nine (SDA-5510) or ten (SDA-5500)
channel plan configuration options. These options allow you to
• Select a channel plan
• Set the video signal type
• Set the channel tuning sequence
• Build a channel plan
• Edit channel plan parameters
• Delete unused channels
• Build sweep points (SDA-5500)
• Specify Auto Test measurements
• Edit Auto Test limits
• Copy a remote plan from another instrument
See Also
½ Chapter 14, "SDA-5500/SDA-5510 Sweep Configuration,"
covers these options in detail.
Sweep Transceiver (SDA-5500)
Selecting the SWEEP TRANSCEIVER option from the main
CONFIGURATION menu takes you to a screen where you can select and
adjust the following seven options:
• Scan mode
• Forward Telemetry Frequency
• Forward Telemetry Level
• Forward Sweep Insertion Level
• Include Audio Carriers
• Enable Reverse Sweep
To Next Page
Loading...
