Chapter 4
Field Sweeping with the SDA-5000
This chapter explains the SDA field units’ sweep function. You’ll first be
introduced to test point compensation. Next you learn how to configure the
field unit to compensate for test point losses and how to calculate those
losses. Configuring your receiver for sweep is covered next, after which you
learn about connecting the SDA-5000 to test points and how to perform
forward and reverse sweeps in the field. Finally, Sweepless and Loopback
sweeping are discussed.
See Also
½ Chapter 14, “SDA-5500/SDA-5510 Sweep Configuration,”
covers the sweep process in detail, as well as providing
information about how the headend and field units work
together to sweep the system.
In aligning a cable network, the important levels, the ones you should care
about, are the system levels within the coax and amplifiers. However, in
INTRODUCTION
TEST POINT COMPENSATION
To Next Page
Loading...
