Channel Plans: Channel Plan Configuration
36
3
To begin, turn the power on and go to the CONFIGURE menu, either by
pressing the Nav key, selecting the Files & Configure tab, and then the
Config icon, or by pressing the green Function key and then 3 ghi.
Depending on your unit’s options, the CONFIGURE menu includes up to six
items (see Fig. 3-1). Use the arrow keys to select the CHANNEL PLAN item
and then press any soft key.
The screen displays the top-level CHANNEL PLAN menu shown in Fig.
3-2.
NOTE: If you have the QAM option, the CHANNEL PLAN
menu will have an Edit Digital Limits option in addition to
those shown in Fig. 3-2.
From this menu you can access submenus that will let you accomplish the
following tasks:
• Select a channel plan
• Set the video signal type
• Set the channel tuning sequence
• Build the channel plan
• Edit the channel plan
• Delete unused channels
• Build sweep points
• Specify Auto Test measurements
• Edit limits
• Edit Digital Limits
• Copy a remote plan from another instrument
The remainder of this chapter will take you through the procedures to
configure each of these functions.
CHANNEL PLAN CONFIGURATION
To Next Page
Loading...
Need help?
General
