Acterna SDA-5000 - Reverse Sweep (SDA-5510); BASIC MODES OF OPERATION; Level Mode

Description and Basic Operation of the SDA-5500 and 5510: Basic Modes of Operation
228
13
• Enable live headend ingress
• Reverse Telemetry Frequency
• Reverse Sweep Plans
See Also
½ Chapter 14, "SDA-5500/SDA-5510 Sweep Configuration,"
covers these options in detail.
Reverse Sweep (SDA-5510)
Selecting the REVERSE SWEEP option from the main CONFIGURE menu
takes you to a screen where you can select and adjust the following options:
• Sweep Mode
• Forward Telemetry Frequency
• Forward Telemetry Level
• Reverse Telemetry Frequency
• Reverse Sweep Plans
• Enable live headend ingress
See Also
½ Chapter 14, "SDA-5500/SDA-5510 Sweep Configuration,"
covers these options in detail.
This section describes the modes of operation for the SDA-5500 and SDA-
5510 headend units.
Level Mode
Signal levels are measured in both the Level and Scan modes. The Level
display provides both a numeric indication of signal level and an analog
meter. The audio and video carrier levels of a channel are displayed
BASIC MODES OF OPERATION