PathTrak Field View (OPT3): PathTrak Mode Operation
147
8
Node Selection
NOTE: Only Broadcast nodes can be selected for viewing.
Broadcast nodes are indicated by a dot to the left of the
node.
Highlight the node you want to view and press this soft key. A
check mark will appear next to the selected node. Once the
desired node is selected for viewing, press the Enter key to go
directly to the PathTrak mode.
Node Information
Select the Information soft key to view measurement
parameters associated with the selected node. These
parameters are established by the PathTrak system
administrator and cannot be changed locally.
Measurement Hold
You can freeze the current measurement at any time by pressing the
Function and 5 mno keys. The measurement is retained even if the jumper
cable is disconnected from the amplifier/node test point. The mode icon in
the upper left-hand portion of the screen flashes when the measurement is
on hold.
To Next Page
Loading...
Need help?
General
