Automatic Test: Performing an Auto Test
188
10
Compensation
Compensation is added directly to the signal level measurements. You can
use this to compensate for losses associated with probe points found on
certain amplifiers. The default is the value specified in the TESTPOINT
screen. Enter a different value in the COMPENSATION screen shown in Fig.
10-8 if necessary, and press the OK soft key to continue.
Fig. 10-8 The COMPENSATION Screen
Results File Name
Enter the name you want to use for the results file at the RESULTS FILE
NAME screen (see Fig. 10-9). The Auto Test software will let you know if you
already have used the name. You can overwrite an existing file of the same
name. When you are ready for the next step, press the OK soft key
To Next Page
Loading...
