ADTRAN TA 5000 User Manual

Section 4, EoCu Provisioning - Create an EFM Bonding Group
65K510DEP08-1A 4-11
Modify a Bonding Group Directly
Tomodifyabondinggroupdirectly,completethefollowingprocedure:
1. FromtheEnableprompt,type
application,andpressENTERtoaccesstheApplication
Configurationprompt.
2. FromtheApplication Configurationprompt,type
ez-efm 1and pressENTERtostartthe
EZEthernetapplication.
3. Ifrequired,modifytheactive‐links‐minimumormodifytheupstreamanddownstream
ratesfromtheEFMConfigurationprompt,type
modify <group_name> link <slot/
port> upstream <0-250000> downstream <0-250000> active-links-minimum
<1-n>
, andpressENTERtomodifyanexistingEFMBondingGroup.
4. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccessthe
GlobalConfigurationprompt.
5. FromtheGlobalConfigurationprompt,type
interface efm-group <group_name>,
andpress
ENTERtoaccessthe EFMBondingGroupConfigurationprompt.
6. FromtheEFMGroupInte rface Configurationprompt,typeoneofthefollowing
commandstoaddorremovealinktotheEFMbondinggroup.
•FromtheEFMGroupInterfaceConfigurationprompt,type
link <slot/port>,
andpress
ENTERtoaddalinktotheEFMbondinggroup
•FromtheEFMGroupInterfaceConfigurationprompt,type
no link <slot/port>,
andpress
ENTERtoremovealinkfromtheEFMbondinggroup
7. FromtheEFMGroupInte rface Configurationprompt,type
exitandpressENTERto
returntotheApplicationConfigurationprompt.

ADTRAN TA 5000 Specifications

General

Brand	ADTRAN
Model	TA 5000
Category	Network Router
Language	English