Total Access 5000 Business Services Deployment Guide
L-8 65K510DEP08-1A
Remote Terminal (RT) Provisioning
Todeploymultiplenodes,completethefollowing:
•ProvisiontheGigESM
Formoreinformation,referto“ProvisiontheGigESM”onpage L‐8.
•ProvisiontheRPRLineModule
Formoreinformation,referto“ProvisiontheRPRLineModule”onpage L‐9.
Provision the GigE SM
Thissubsectiondetailsthefollowing information:
•ProvisiontheTimingSource
•ProvisiontheHopCount
Provision the Timing Source
PrimaryandsecondarysourcesmustbeconfiguredtoreceivetimingfromLoopAandLoopB
whereLoopAisthelowernumbered(oddorWest)RPRLineModuleandLoopBisthehigher
numbered(evenorEast)RPRLineModule.Tosetthetiming,completethefollowing:
1. FromtheSwitchModulemenu,select
Provisioning,andpressENTER.
2. FromtheProvisioningmenu,select
Timing,andpressENTER.
3. FromtheTimingmenu,select
Primary Source,andpressENTER.
ThePrimarySourceprovisionsthelocalinputfortheprimaryclockgeneration.
4. FromthePrimaryTimingSourcemenu,select
Source,andpressENTER.
5. FromtheSourcemenu,select
LoopA,andpressENTER.
6. FromtheLoopAmenu,selecttheappropriateslot,andpress
ENTER.
7. FromtheTimingmenu,select
Secondary Source,andpressENTER.
TheSecondarySourceprovisionsthelocalinputforthesecondaryclockgeneration.
8. FromtheSecondaryTimingSourcemenu,select
Source,andpressENTER.
9. FromtheSourcemenu,select
LoopB,andpressENTER.
10. FromtheLoopBmenu,selecttheappropriateslot,andpress
ENTER.
Provision the Hop Count
HopCountmustbeenabled.ToenableHopCount,completethefollowing:
1. FromtheSwitchModulemenu,select
Provisioning,andpressENTER.
2. FromtheProvisioningmenu,select
Timing,andpressENTER.
3. FromtheTimingmenu,select
Hop Count,andpressENTER.
4. FromtheHopCountmenu,select
Enabled,andpressENTER.