ADTRAN TA 5000 User Manual

Section 5, BSM Provisioning - Provisioning Summary
65K510DEP08-1A 5-3
Provisioning Summary
ToprovisionforBSM,completethefollowingprocedure:
1. ProvisiontheLineModule.
Formoreinformation,referto“ProvisiontheLineModule”onpage 5‐4.
2. CreateaPoint‐to‐PointProtocol(PPP)groupconsistingofT1interfaces,andassigntheIP
addressofthesubtendeddevice,theIPaddressoftheEdgerouter,
andanyDNS
addressestothecreatedPPPgroup.
TheIPaddressandtheDNSaddressesarepusheddowntothecustomerrouter
subtendedofftheTotalAccess5000.
Formoreinformation,referto“CreateaPoint‐To‐PointProtocolGroup”onpage 5‐7.
3. CreateanEVCtoconnectthePPPgroup
toaVLANgoingouttheGigabitEthernetport,
totheEdgerouter.
Formoreinformation,referto“CreateanEVCCrossConnect”onpage 5‐12.
4. CreateanEVCmaptodefinetheDSCP‐to‐prioritybitmappingandtocreatetheEVC‐to‐
PPPgroupmapping.
Formoreinformation,referto
“CreateanEVCMapontheTotalAccess5000”onpage 5‐
15.

ADTRAN TA 5000 Specifications

General

Brand	ADTRAN
Model	TA 5000
Category	Network Router
Language	English