To Next Page

To Previous Page

Section 4, EoCu Provisioning - Disable Unused NetVanta 838 Interfaces

65K510DEP08-1A 4-33

Disable Power Feed Alarms

Todisablethepowerfeedalarms,completethefollowingprocedure:

NOTE

Apowerfeedinputcannotbedisabled,butifbothinterfacesarenotbeing

sourcedwith±48VDCor ±24VDCpowering,thereisapowerfailalarm

activefortheunusedinput.

1. FromtheEnableprompt,type

configure terminal,andpressENTERtoaccesstheGlo‐

balConfigurationprompt.

2. FromtheGlobalConfigurationprompt,accessthesystemalarmpromptbytyping

system-alarm,andpressENTER.

3. IfpowerfeedAisunused,disablethepowerfeedAalarmbytyping

no alarm enable

power-fail dc a

,andpressENTER.

4. IfpowerfeedBisunused,disablethepowerfeedBalarmbytyping

no alarm enable

power-fail dc b

,andpressENTER.

5. Type

end,andpressENTERtoreturntotheEnableprompt.

ThepowerAorBfailalarmshouldbeclearedinthealarmlog.

Onceallunusedinterfacesaredisabled,thealarmsfortheseinterfacesshouldnowbecleared.

Ifallin‐useinterfaces(SHDSL,Ethernet,Gigabit‐Ethernet,andpower)areinnon‐alarmed

states,

thentheAlarmLEDontheNetVanta838shouldnowbelitsolidgreen.

Clear the Alarm Log

BeforeclearingtheAlarmLog,thealarmsmustfirstbeacknowledged.

TocleartheAlarmLog,completethefollowingprocedure:

1. FromtheEnableprompt,type

force alarm acknowledge,andpressENTER.

2. Clearthealarmlogbytyping

force alarm clearandpressingENTER.

3. Verifytherearenoalarmsbytyping

show alarm logandpressingENTER.

ADTRAN TA 5000 User Manual

Questions and Answers: