ADTRAN TA 5000 User Manual

Section 6, EoTDM Provisioning - Disable Unused NetVanta 800 Interfaces
65K510DEP08-1A 6-29
Disable Ethernet Interfaces
ForeachEthernetportthatisnotinuseforcustomerservices,completethefollowing:
NOTE
ThismustbedonetocleartheEthernetlinkdownalarms.
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,accesstheunusedEthernetPortConfiguration
promptbytyping
interface ethernet 1/0/<port>,andpressENTER.
3. DisabletheEthernetportdownbytyping
shutdown,andpressENTER.
TheEthernetlinkdownalarmshouldnowbeclearedforthisportinthealarmlog,and
theportʹsLEDshouldbeoff.
4. Repeatsteps2and3fortheremainingunusedEthernetports.
OnceallunusedEthernetportshavebeendisabled,allEthernetalarmsshouldbecleared
inthe
alarmlog.
Disable the Gigabit-Ethernet Interface
TodisabletheGigabit‐Ethernetport,completethefollowing:
NOTE
Aportmustbeplacedoutofservice,regardlessofSFP pr esence ,toremove
thealarms.
IftheportisenabledandnoSFPispresent,therewillbeanalarmfornoSFP
beingpresent.
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,accesstheGigabit‐EthernetPortConfiguration
promptbytyping
interface gigabit-ethernet 1/0/1,andpressENTER.
3. DisabletheGigabit‐Ethernetportbytyping
shutdown,andpressENTER.
TheGigabit‐Ethernetlinkdownalarmshould nowbe clearedinthealarmlog,andtheportʹs
LEDshouldbeoff.

ADTRAN TA 5000 Specifications

General

Brand	ADTRAN
Model	TA 5000
Category	Network Router
Language	English