Section 5, BSM Provisioning - Create a Point-To-Point Protocol Group
65K510DEP08-1A 5-11
Add a Link to the PPP Group
ToaddalinktothePPPgroup,completethefollowingsteps:
1. FromtheEnableprompt,type
show interfaces ppp-group,andpressENTERtoview
allPPPgroupsintheTotalAccess5000.
Asan alternative,type show ppp-group <shelf>or show ppp-group
<shelf/slot>
toseeanabbreviatedlistofppp‐groups/linksontheshelfor
theslot.
2. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccessthe
GlobalConfigurationprompt.
3. FromtheGlobalConfigurationprompt,type
interface ppp-group <shelf/slot/
group>
,andpressENTERtoaccessPPPGroupInterfaceConfigurationprompt.
4. Ifaddingasecondlink,MultilinkPPPmustbeenabled.FromthePPPGroupInterface
Configurationprompt,type
ppp multilink,andpressENTER.
5. FromthePPPGroupInt erfaceConfigurationprompt,typeoneofthefollowing
commands:
•ToprovisiontheCHDS3PPP/MLPPP3‐PortLineModule,type
link <slot/
port:channel>
,andpressENTERtoaddalinktothegroup
•ToprovisiontheDS1PPP/MLPPP32‐PortLineModule,type
link <slot/port>,
andpress
ENTERtoaddalinktothegroup
Delete a Link from the PPP Group
ToremovealinkfromthePPPgroup,completethefollowingsteps:
1. FromtheEnableprompt,type
configure terminal,andpressENTERtoaccesstheGlo‐
balConfigurationprompt.
2. FromtheGlobalConfigurationprompt,type
interface ppp-group <shelf/slot/
group>
,andpressENTERtoaccessPPPGroupInterfaceConfigurationprompt.
3. FromthePPPGroupInt erfaceConfigurationprompt,typeoneofthefol lowing
commands:
•ToprovisiontheCHDS3PPP/MLPPP3‐PortLineModule,type
no link <slot/
port:channel>
,andpressENTERtoremovealinktothegroup
•ToprovisiontheDS1PPP/MLPPP32‐PortLineModule,type
no link <slot/
port>
,andpressENTERtoremovealinktothegroup