ADTRAN TA 5000 User Manual

Appendix J, GigE Star Provisioning - Central Office Terminal (COT) Provisioning
65K510DEP08-1A J-9
• None:Whenselected,thisoptiondoesnotsetthetimingsourcetotheDS1.Timing
defaultstothetimingsetintheGigESM.
Provision the Uplink Identifier
TheuplinkidentifiersettingsaredepdendantontheNodesconnectionthroughtheEFMcard.
Tosettheuplinkidentifierfor theCOT,completethefollowing:
1. FromtheProvisioningmenu,select
EFM Setting,andpressENTER.
2. FromtheEFMSettingsmenu,select
Uplink Identifier,andpressENTER.
3. FromtheUplinkIdentifierSystemmenu,select
System,andpressENTER.
Provision the DS1 Interface
ToprovisiontheDS1Interfaces,completethefollowing:
1. FromtheT18‐PortMainmenu,select
Provisioning,andpressENTER.
2. FromtheProvisioningmenu,select
DS1 Interfaces,andpressENTER.
3. FromtheDS1Interfacemenu,selecttherequiredDS1,andpress
ENTER.
4. FromtheDS1PortProvisioningmenu,select
Service State,andpressENTER.
5. FromtheServiceStatemenu,select
In Service,andpressENTER.
6. FromtheDS1PortProvisioningmenu,select
Line Buildout,andpressENTER.
Thisoptionsusedforprovisioningboththecablelength(infeet)andthetransmitpulse
shapeandattenuationappliedtothetransmitsignal.Usingthe0dBsettingprovidesfor
thelongestcircuitlength.Thevalidoptionsare:
•0–133ft
• 133–266ft
• 266–399ft
• 399–
533ft
• 533–655ft
•0dB
• –7.5dB
• –15dB
• –22.5dB
7. FromtheOutputLBOmenu,setthelinebuildout,andpress
ENTER.
8. FromtheProvisioningmenu,select
EFM Setting,andpressENTER.
9. FromtheEFMSettingmenu,select
DS1 Bonding,andpressENTER.

ADTRAN TA 5000 Specifications

General

Brand	ADTRAN
Model	TA 5000
Category	Network Router
Language	English